Problem: Your outside antenna is pulling in too much signal from the cell tower. Make sure to power off & power on your signal booster to make sure it's updating correctly. Usually, it's easiest to move the inside antenna around until the lights are solid green. Solution: Increase the distance of the two antennas with a minimum of 20 feet vertically or 50 feet horizontally. Your amplifier still works, however, it's operating at reduced power, meaning you're not getting maximum boost. Problem: Your outside antenna is pulling in signal from the cell tower AND your inside antenna. Make sure to power off, power on your booster to ensure the amplifier is updating the light status. Solution: You need to point the outside antenna slightly away from the cell tower. So to avoid overloading your amplifier, it has to shut down. This means the outside antenna is pulling in TOO much signal from the cell tower. Problem: Well, this is actually a "good" problem. Power off your booster, then power it on again and if you put enough distance between the two, you'll have green lights. If you have a model that has a yagi uni-directional outside antenna (triangular-shaped), make sure it points to the cell tower with the inside antenna pointed away from the yagi. Solution: You need to increase the distance of the two antennas with a minimum of 20 feet vertically or 50 feet horizontally. This is called a feedback loop or oscillation (like a snake eating its own tail). Problem: Your outside antenna is pulling in signal from your inside antenna instead of the cell tower. Grab a beer, glass of wine, or your favorite drink and start binge watching on Netflix. Your signal booster is amplifying at maximum capacity. For Commercial Meaning of Lights on a weBoost GreenĮverything is working perfectly.
0 Comments
Leave a Reply. |